Fill pinholes and sand scratches with our Polyester Glazing Putty...even on large areas.
- Fills pinholes
- Sands scratches and imperfections
- Can be applied to large areas without distortion
- Mix with other body fillers
Before painting, use this glazing putty to fill pinholes and sand other minor imperfections that can ruin the look of your final finish. Use over sanded substrates, steel and galvanized steel.
Thoroughly mix desired amount of material with cream hardener. Using a clean spreader, fill to desired level. Do not exceed 1/16" depth. Allow to cure for at least 15 minutes before sanding. Abrade with 80-grit and follow up with 120-180-grit to achieve desired contour. Final finish with finer abrasives. Topcoat with quality primer, such as Eastwood’s Epoxy or Urethane Primers.
CAUTION: Do NOT return catalyzed material back into can. To avoid contamination, seal lid tightly after each use. Store in a cool dry place.
Always wear eye, skin and respiratory protection when using this product. Always apply in a well-ventilated area. Consult MSDS and product label for specific safety warnings.
Eastwood Offers Free Lifetime Technical Support
Attention California Residents - Proposition 65
WARNING - Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Questions & Answers
You may also be interested in the following product(s)
Starting at: $27.99
Starting at: $32.99