The Eastwood MIG 250 with its state of the art inverter technology weighs 1/2 as much as similar welders. It delivers all the power you will ever need to weld aluminum and steel up to a ½ inch thick.
- 120 or 240 volt powered
- Infinitely adjustable 30-250 amp welding range
- 60% duty cycle at 250 amp setting
- Weighs just 66lbs
- State of the art inverter technology
- Uses 4 in or 8 in wire spool
The Versa-Cut 60 amp output plasma cutter is designed to cut steel, aluminum and stainless steel from 0.010 to 0.875 inch with ease.
- 220VAC input with inverter technology
- 20' torch cable and clamp
- Rated 60-amp output
- Duty cycle:60% at 60 amps
- Weighs 45 lbs
- Air flow requirements: 5-7cfm at 60 psi
- Cuts up to 7/8" thick material
The Welding Cart is Eastwood-designed to hold our welders plus our Plasma Cutters all on the same cart! Will also accommodate welding accessories and bottle.
About Eastwood MIG 250 AMP Welder Plasma Cut 60 and Cart
MIG250 and the cut 60 with cart. The MIG250 with inverter power source is compatible with steel, stainless and, with our #13898 spool gun, will weld up to 1/4 inch aluminum. The Versa Cut 60 is a powerful 220 volt plasma cutter that can cut up to 7/8in of steel. The Versa-Cut 60 requires a 50 amp breaker. The 11616 cart offers convenient storage of both units and quick set up when needed.
20279 MIG250 welder
14099 Versa Cut 60 Plasma Cutter
11616 Multi Unit Welding Cart
Use standard 120VAC, 20 amp 50 or 60Hz power. Welds up to 140 map on 120VAC. The mig 250 will also use standard 240VAC, single phase 50 or 60Hz power. Unit will weld up to 250 amps with 240 VAC input. Use a NEMA 650 receptacle and a 50 amp dedicated line for this machine.
Always follow manufacturer's instructions for proper safety requirements when performing welding tasks.
Eastwood Offers Free Lifetime Technical Support
Attention California Residents - Proposition 65
WARNING - Cancer and Reproductive Harm - www.P65Warnings.ca.gov