Customize parts and accessories quickly using this sheet metal punch and die set. These metal cutting tools add a perfectly shaped hole with a quarter-inch downward flare without a press. All that is needed to create a hole and flare is a ½-inch pilot hole, something to secure the bottom half of the die such as a vise) and either a ¾-inch or 18mm socket hand wrench. It’s an easy process that can be done on a vehicle, on the workbench or at a job site.
We’ve developed four different sizes of sheet metal punch dies to make speed holes, custom battery trays, drainage holes and more. Punch and flare a 1-inch, 1.5-inch, 2-inch or 2.5 inch hole that also improves the strength and structural integrity of the part. Watch our videos above or check out this tech tip article in the Eastwood Garage to learn more about how to use the punch and flaring die set. All Eastwood tools come with free lifetime technical support from our DIY automotive experts.
- Punches a clean hole and produces a smooth flare
- Made of Hardened Steel
- Handles up to 16 gauge mild steel, 19 gauge stainless and 14 gauge aluminum
1 - Punch and Flare Die Set
Handles up to 16 gauge mild steel, 19 gauge stainless and 14 gauge aluminum.
20530 punches 1 inch ID hole: Total size with flare :1.65"
20355 punches 1.5 inch ID hole: Total size with flare 2.25"
20331 punches 2 inch ID hole: Total size with flare 2.6"
20332 punches 2.5 inch ID hole: Total size with flare 3.15"
Always wear appropriate eye and ear protection. Keep fingers away from moving parts
60 Day Warranty
Eastwood Offers Free Lifetime Technical Support
Attention California Residents - Proposition 65
WARNING - Cancer and Reproductive Harm - www.P65Warnings.ca.gov