50-lb. "High-Flow" Pressure Blaster helps you remove rust and paint faster.
- 50-lb. media capacity
- Large 1/2"-I.D. blaster hose and fittings
- 8'-long, heavy-wall blast hose with dead-man valve
- Requires just 10 cfm at 90 psi
- All-steel welded top-loading hopper and pressure gauge
Eastwood's "High-Flow" Pressure Blaster features high-volume, extra-large valves, which means more air volume and more abrasive flow for faster removal of rust and paint.
About Eastwood 50lb Pressure Abrasive Blaster
Sturdy welded hopper, 1/2" heavy-duty nozzle, heavy-wall blast hose and safety pressure-relief valve make this one rugged, durable, and very efficient abrasive blaster. Don't skimp with one of those low-cost units that frustrate you with clogging and sporadic media spraying. This Eastwood pressure blaster completely strips the average frame in less than a day, rather than weeks using other units or methods. Designed for high flow with minimal air input; a compressor producing a minimum of 10 cfm at 90 psi will work fine. 10"W x 14"L x 33"H.
Rolls easily to your job site. For best results and the most efficient operation, use clean, dry, 80-grit or finer abrasive media. Use of Walnut shell media is not recommended. 1-year limited warranty.
50-lb.-capacity Blaster (15-30 minutes of blasting)
1/2"-ID x 8'-long Hose
4 Ceramic Nozzles (2.0, 2.5, 3.0 and 5mm)
WARNING: Blasting emits abrasive under pressure. Adequate respiratory, eye, and body protection must be worn during use. Inhalation of silica-based media particles have been known to cause cancer and other deadly diseases, and must be avoided. Wear NIOSH- approved respiratory protection while operating this equipment.
Eastwood Offers Free Lifetime Technical Support
Attention California Residents - Proposition 65
WARNING - Cancer and Reproductive Harm - www.P65Warnings.ca.gov