- Eastwood Contour Aluminum Reinforced Repair Compound Body Filler
Eastwood Contour Aluminum Reinforced Repair Compound Body Filler
Item #13518ZP Brand: Eastwood
stronger, corrosion-resistant repair
Contour™ Repair Compound is reinforced with aluminum for a stronger, corrosion-resistant repair.
- Superior corrosion resistance and adhesion
- Repair factory-leaded seams and high-strength applications
- Perfect for areas prone to moisture
- Includes hardener
Fortified with aluminum particles
Eastwood's uniquely formulated filler is fortified with aluminum particles to produce a repair with extra strength, corrosion resistance and durability in galvanized steel and aluminum. Includes Liquid Hardener.
Smooth Rough Castings
A uniquely formulated filler fortified with aluminum for strength, corrosion resistance and durability. Use to repair factory leaded seams and high strength applications as well as areas prone to moisture. Its corrosion resistant properties prevent rust from coming through the repair.
Filler: 25.3 oz/750 mL Blue Hardener: 0.5fl oz/14mL
13521 ZP EW Contour Glazing Putty 10041Z PRE Painting Prep 13919 Eastwood Filler Spreaders 31273 Eastwood Filler Mixing Board 31160 Dura Block Sanding Boards 21538 Larry Lyles Body Work DVD 43579 DA Orbiting Sander 43120 Eastwood Work-Fender Stand
Thoroughly mix desired amount of material with blue liquid hardener. Using a clean spreader, fill to desired level. Do not exceed 1/4" depth. Allow to cure for at least 15 minutes before sanding. Abrade with 40-80 grit and follow up with 120 grit to achieve desired contour. Final finish with finer abrasives. If necessary, apply Eastwood’s 13521ZP Contour™ Glazing Putty for final finishing. Topcoat with quality primer, such as Eastwood’s Epoxy or Urethane Primers.
CAUTION: Do NOT return catalyzed material back into can. To avoid contamination, seal lid tightly after each use. Store in a cool dry place.
Always wear eye, skin and resporatory protection when using this product. Always apply in a well ventilated area. Consult MSDS and product label for specific safety warnings.
Made in Canada to Eastwood's specifications and quality standards
Surface must be clean and free of wax, grease and debris. Abrade surface using 36 grit, or finer. Thoroughly mix desired amount of material with 2% liquid hardener. Do not exceed 1/4" depth. Allow to cure 15 min before sanding. Abrade with 40-80 grit and follow up with 120 grit to desired contour. If necessary, apply Eastwood's Polyester Glazing Putty (13521ZP) for final finishing. Topcoat with quality primer such as Eastwood's Epoxy or Urethane Primers. Do NOT return catalyzed material back into can.
Questions & Answers
Customers also viewed:
Repair rusted-out spots, holes, tears and cracksOnly $49.99
Sprayable high-build filler is an excellent base for any paint system
Starting at: $8.99
1-step filler actually inhibits rust and self-etches, to save you time
Starting at: $24.99
Fill pinholes, sand scratches, polyester putty...even on large areas
Starting at: $13.29
Sands all types of flat and contoured surfaces; use wet or dryOnly $59.99
Stronger-than-it-looks portable stand holds up to 750 lbs.!Only $29.99