EW Urethane Clear 2:1 Quart

MIXING RATIO

Thoroughly mix two parts 50250ZP HS Clear in gallons or 50251ZP HS Clear in quarts, with one part 50252ZP HS Clear Activator. For even better spray-ability, 2:1 mix may be reduced with a urethane-grade reducer or other appropriate solvent product. Doing this will improve the flow and leveling. Eastwood suggests using a Zero-VOC reducer to avoid potential compliance issues.

Use caution in mixing materials as HS Clear may begin to gel after approximately two hours (at 70 °F).

SPRAY GUN SETUP

• HVLP Gun: Fluid Tip 1.3-1.5 mm Inlet Spray Pressure 25-30 psi
• Conventional Gravity: Fluid Tip 1.3-1.6 mm Inlet Spray Pressure 45-50 psi
• Conventional Siphon: Fluid Tip: 1.4-1.8 mm Inlet Spray Pressure 45-50 psi

APPLICATION INSTRUCTIONS

Apply Eastwood HS Clear in two medium wet coats, with a 10-minute flash period between each. Clear should be dry to the touch within 10 minutes, and will be tack-free within three hours (at 70 °F). Do not recoat between one and eight hours after previous coat. Additional coats may be applied after eight, but before 18 hours (at 70 °F) have passed from completion of previous coat. Ideal application temperature is between 70°F and 90°F.

For increased depth and gloss, well cured clear may be wet sanded and recoated with one to two additional wet coats.