Description
Action +Plus Intake Manifold 351M, 400M V8 (2V Heads)
Features:
- Power band: Idle-6000 RPM
- Port Size: 1.85” height 1.32" width
- Height: Front 3.75", Rear 4.75"
- No EGR provisions
- Square Carburetor Mounting Flange
- Dual Plane Design
Warranty
1 Year Manufacturers Warranty
Specifications
Barrels: 4<br> Brand: Weiand<br> Construction: Cast<br> Emission Code: 3<br> Engine: Ford Small Block V8<br> Finish: Satin<br> Front Height: 3.75 inch<br> Fuel System Type: Carb<br> Manifold Type: Low Rise<br> Product Type: Intake Manifold<br> Rear Height: 4.75 inch<br> RPM Power Band: Idle-6000<br> Warranty: Limited 90 Day<br> Part Number: 8010<br> <b>EMMISIONS</b><br><br> <p>This part is legal for sale and use on Uncontrolled (Non-Emissions Controlled) Vehicles and Racing Use Only Vehicles.</p><br /> <p>The following vehicles are considered Uncontrolled (Non-Emissions Controlled) Vehicles:</p><br /> • 1965 and older U.S. manufactured California Certified vehicles<br /> • 1967 and older U.S. manufactured Federally Certified vehicles<br /> • 1967 and older Foreign manufactured vehicle<br /><br /> The following vehicles are considered Racing Use Only Vehicles: <br /><br /> • Racing Use Only Vehicles are vehicles that are used exclusively for competition and that are not registered and that may never be used on the street<br /><br /> <b><u>WARNING: It is against the law to install this part on an Emissions Controlled Vehicle</u></b><br /><br /> The following vehicles are considered Emissions Controlled Vehicles: <br /><br /> • 1966 and newer U.S. manufactured California Certified vehicles<br /> • 1968 and newer U.S. manufactured Federally Certified vehicles<br /> • 1968 and newer Foreign manufactured vehicle
In the Box
Contents
(1) Ford Small Block Weiand Action +Plus Intake 8010
Guides & Accessories
Instructions
<p><a href="https://documents.holley.com/w501rev2.pdf" target="_blank"><i><b>Instructions for Part# 8010</b></i></a></p><br /> <p><a href="https://documents.holley.com/w537rev.pdf" target="_blank"><i><b>General Information for Part# 8010</b></i></a></p><br /> ***In order to use a valley tray/pan with this manifold, a clearance cut will need to be made for the locating dowels.