No one’s perfect, but we can do our best to strive to get the closest we can get to perfection every day. These ideals are the same whether you’re a cook, a machinist, a landscaper, or a guy in his garage building an old car or motorcycle. One big lesson I’ve learned over the past few years has been to slow down and take the time to make sure that parts fit together as nice as possible before welding. Just blindly rough cutting a piece and trying to make it fit another piece is going to end with an uneven weld seam and won’t end well!
Tag: tech tuesday
Tech Tip- How to Move a Bent Edge
On my Model A project I channeled the car down over the chassis which required me to build new floor supports and pans. The way I built it all up I needed to make 6 small pans that would fit down in between each supports. This meant I had to nail the bends on either edge so the final inside measurement allowed the pans to drop down in between the supports tightly. I will have to take the pans in and out throughout the rest of the project so I wanted them to drop in and fit snug, but not so tight I needed to use a hammer to force them in (this could also bow the panel).
How to make a Custom Metal Hood Scoop from Scratch- With Ron Covell
Ron Covell is a master of forming sheet metal by stretching, bending and shaping. He has made a series of how to DVDs which Eastwood carries, in which he teaches you how the things he makes look so easy. He also does classes and workshops all over the country, including at Eastwood headquarters in Pennsylvania. He uses our tools, and for several years now he has attended the SEMA show in Las Vegas and demonstrated them, from hammer, sandbags and dollies to the English Wheel.
One of the projects he likes to use as an example is a traditional styled, hot rod hood scoop out of 1/16 inch thick aluminum, from start to finish in less than an hour.