- Eastwood Magnetic Plasma Cutting Guide
Is it for use with a drag tip?
If the magnetic side is used on steel, can it be re-used?
Eastwood Magnetic Plasma Cutting Guide
Item #20188 Brand: Eastwood
Flexible Plasma Cutting Guide ensures accurate cuts when cutting curves or on compound surfaces.
- Magnetic and adhesive for use on any surfaces
- Flexible to cut most shapes
- 1/2" x 20' Roll
One side is magnetized for use on steel while the other side has adhesive for use on non-magnetic surfaces such as aluminum. Disposable guide measures 1/2" wide and comes in a 20' roll. A must have for plasma cutting patch panels or for use on contoured panels were straight edge won't work
20 ft long, 1/2 inch wide and 1/16 inch thick
Always wear appropriate safety equipment when plasma cutting.
Click here to see safety products
Use the disposable plasma cutting guide to assure accurate work in straight line cutting or gentle curves. Adheres with either the adhesive tape side (remove white paper to expose adhesive tape) or by magnetism on bare, clean steel.
Note: On steel pieces over 1/8” thick use the adhesive side to assure guide stays in place as the slower cutting speeds and greater heat tends to reduce magnetism in guide.
Questions & Answers
Customers also viewed:
40 Amps output cuts up to 3/8" 110/220v inputOnly $549.99
100% cotton jacket is flame-resistant, anti-static, and mildew-resistant
Starting at: $36.99
Easily cut straight lines, curves, radii and circlesOnly $49.99