Flexible Plasma Cutting Guide ensures accurate cuts when cutting curves or on compound surfaces.
- Magnetic and adhesive for use on any surfaces
- Flexible to cut most shapes
- 1/2" x 20' Roll
One side is magnetized for use on steel while the other side has adhesive for use on non-magnetic surfaces such as aluminum. Disposable guide measures 1/2" wide and comes in a 20' roll. A must have for plasma cutting patch panels or for use on contoured panels were straight edge won't work
20 ft long, 1/2 inch wide and 1/16 inch thick
Always wear appropriate safety equipment when plasma cutting.
Click here to see safety products
Use the disposable plasma cutting guide to assure accurate work in straight line cutting or gentle curves. Adheres with either the adhesive tape side (remove white paper to expose adhesive tape) or by magnetism on bare, clean steel.
Note: On steel pieces over 1/8” thick use the adhesive side to assure guide stays in place as the slower cutting speeds and greater heat tends to reduce magnetism in guide.
Eastwood Offers Free Lifetime Technical Support
Attention California Residents - Proposition 65
WARNING - Cancer and Reproductive Harm - www.P65Warnings.ca.gov