Dress Up Your Calipers! Nothing ruins the appearance of a sharp set of wheels like dirty, corroded calipers lurking from behind. Now dress up those steel or aluminum calipers with a super-tough durable finish that will make your car or truck look terrific. Our new caliper paint is beautiful in appearance, and strong enough to withstand the punishment of road debris and temperature extremes, and it looks terrific on any car or truck. Then, whenever your calipers get covered with dirt and brake dust, clean them with anything you like; the POR-15 Caliper Paint will stand up to just about anything.
This Complete Kit withstands temperatures up to 500 Degrees while providning an incredibly durable finish.
(1) 8oz. POR-15 Cleaner Degreaser
(1) 8oz. POR-15 Metal Prep
(1) 4oz. POR-15 Rust Preventative
(1) 4oz. POR-15 Caliper Paint
(2) Paint Applicators
Step 1: Remove all four wheels from vehicle. Calipers don’t need to be removed. Don’t remove brake line.
Step 2: Clean surfaces to be painted with POR-15 Cleaner Degreaser. Spray on the cleaner and brush the dirt, grease and grime with a small scrub brush or toothbrush. Wear protective gloves and glasses when cleaning your calipers. Read directions on POR-15 Cleaner Degreaser container before using.
Step 3: Rinse cleaned caliper thoroughly with water and dry with clean towel. Now apply POR-15 Metal Prep and keep surface wet for 20 minutes and then wash off POR-15 Metal Prep with water and dry thoroughly.
Step 4: Mask off the areas not to be painted. Tape off the brake bleeder screw, brake lines, and caliper piston boots and anything else you don’t want painted.
Step 5: Open the small can of POR-15 Rust Preventive Coating and stir, making sure the contents are thoroughly mixed. Using a foam brush (included in your kit) paint the caliper evenly, making sure the coating is evenly applied but not to the point where the paint runs. Because this is a rust preventive coating you want to be sure you don’t miss any spots which could rust later if not covered.
Step 6: When the POR-15 Rust Preventive Coating is just dry to the touch, with slight finger-drag remaining, normally in the 2-5 hour range, it’s ready for the POR-15 Caliper Paint to be applied. Open the can of POR-15 Caliper Paint, stir thoroughly, and apply the first coat in thin but even strokes. When the first coat is dry (3 -4 hours), apply a second coat to achieve a beautiful ceramic-like finish.
These products should only be handled when wearing latex gloves, eye protection, and NOSHA approved respirator. Always work in a well ventilated area.
To get $10 OFF your order!