POR-15 Engine Enamel high temperature engine paint is formulated to be the finest engine paint available, with a richness and depth of color unsurpassed by any other paint of its type. The finest pigments and color ingredients have been used in sufficient quantities which mean more paint on your engine and less solvent dissipated into the atmosphere.
- Temperatures up to 350°F
- Matches Original Factory Colors
- Guaranteed Not to Burn Off
- Professional Use
POR-15 Engine Enamel flows easily, covers better than any other engine paint, and lasts longer. Our enamels are non-flammable and can easily handle temperatures up to 350°F without discoloring. POR-15 Engine Enamel conforms to even the strictest California environmental standards. We invite you to compare them with any other product and you'll see what we mean. We formulated POR-15 Engine Enamel to be the best and most beautiful engine enamel you can buy.
Typically, a pint is enough for an entire engine.
(1) Pint POR15 High Temperature Engine Paint
Bare Steel: Remove grease, oil, and other foreign substances with water based POR-15 Cleaner Degreaser then rinse with water. If surface was previously painted, sand with 320 grit sandpaper or a POR-15 Scuff Pad then apply POR-15 Engine Enamel. If surface is bare or rusted metal you must use POR-15 Metal Prep to prepare surface before painting. Spray or brush POR-15 Metal Prep onto surface and keep wet for 10-20 minutes then rinse thoroughly with water. For best results, next apply one coat of POR-15 Rust Preventive Coating. When POR-15 Rust Preventive Coating is dry to the touch with slight finger drag (approximately 2 to 6 hours) apply POR-15 Engine Enamel directly over POR-15 Rust Preventive Coating.
Apply in well-ventilated area only. Ideal ambient temperature for application is 70°F, but an acceptable temperature range is between 50-80°F. Mix POR-15 Engine Enamel by stirring only. Do not shake. POR-15 Engine Enamel can usually be brushed without thinning. A full coat will usually cover but if a second coat is needed, apply when first coat is dry to the touch (no finger drag) and within 24 hours of first coat.
Dry Time: Wait 4-6 days before starting engine.
Previously Finished or Primed Surfaces: Using POR-15 Cleaner Degreaser ensure that the surface is clean, dry, and free from oil, grease, dirt, salts, and any other contaminants. All blistered and loose paint must be removed. Glossy surfaces should be roughened with 320 grit before recoating.
Always wear proper personal safety equipment when using this product. Always use in a well ventilated area.
Eastwood Offers Free Lifetime Technical Support
Attention California Residents - Proposition 65
WARNING - Cancer and Reproductive Harm - www.P65Warnings.ca.gov