(Q) Do I need a 220-volt system to operate this?
(A) No, standard 110v will work.

(Q) Do I need a welding mask when using this?
(A) It’s not necessary, but don’t look directly into the momentary flash.

(Q) How do I get the pins off after they’ve been welded onto the surface?
(A) After you’ve made your pulls, simply snip or grind the pins off.

Super Pro Plus Stud Welder Kit includes the 110vAC, 2,000-amp stud gun; Magna T-Puller; twist-on/off slide hammer; 500 draw pins (250 each: 2.0mm, and 2.5mm for heavier-gauge rocker panels); 150 trim rivets; trim rivet tip; shrinking tip; magna wire tip; 1/2-lb. of Magna Wire for welding along creases; instructions; all in a molded storage/carry case.

Always wear eye protection, as well as gloves and long sleeves, when using this product. Typically there are no sparks emitted when welding, but as a precaution, make sure there are no flammables in the immediate area. 31014 Shoot Suit Welded Stud Puller

The Stud Welder Dent Pulling System makes pulling dents from one side possible without drilling holes! Easy to use, simply remove paint from area to be repaired. Load draw pin into gun, push spring loaded stud welder gun against surface until outer contact ring touches surface, and depress the switch for.5 to 1 second to anchor the pin. Twist on the slide hammer pull out dent until flush. On larger dents when using multiple pins gradually work each pin in turn until surface is level.