A few years back, our guy Matt got hold of an old Cushman motor scooter. True to Eastwood tradition, it was a rusty pile – not much more than a starting point. Matt had plans to not only bring back the looks of the old icon, but also give it […]
Eastwood Projects
Projects – That Time We Built a Go Kart
We spend a lot of time talking about restoration and repair on older vehicles. But once an upon a time, we decided to try something a little different. We built a go kart. From scratch. Over the course of a ten-part series, the Eastwood video team built a traditional single-seat, […]
Project Sunny – Episode 8: Reworking the Cargo Floor
Do the job right! That’s been Eastwood’s motto for a long time. Taking that motto to heart, I couldn’t walk away from the previous episode of Project Sunny feeling right. Sure, I got the two pieces of the floor stitched together into one piece, but I wasn’t happy with how […]
Bagged C-10 – Episode 5: Rusty Frame Repair and Repaint
In this episode, Adam covers all the steps required to repair the cracks in 10-year-old frame notch kit as well as years of general rust damage. In the process, he repaints the entire frame behind the cab while the bed is still off. Watch the video to see how nice […]
Bagged C-10 – Episode 4: Making New Brake Lines From Scratch
While Adam had the bed off his C-10 for chassis refinishing, he decided to overhaul his old brake lines. The original equipment brake lines were rusting from the inside and showing signs of fatigue from past work. The original flares were leaking as well, and the heads of the fittings […]
Bagged C-10 – Episode 3: Fabricating a Custom Notch Cover
Adam’s 1985 Chevy C-10 pickup project continues with the addition of a custom cover for the notched frame. Until now, he’s been hiding notch job with some wooden boards. But he’s decided it’s time to get serious make a sheet metal panel in preparation for a new bed finish. In […]
Project Sunny – Episode 7: Rear Floor Structure Complete
Project Sunny returns with a new episode after a bit of a break for other projects. In this new episode, Bryan explains why he has reworked the floor panel support rails he’d previously made. The new pieces are a major improvement, as you’ll see. He also tackled the problem of […]
Mark’s Trans Am – Episode 10: Rustproofing the Insides of the Frame
Mark is back to work on the front subframe on the Trans Am project. Now that the outside of the metal is looking like new, he tackles rust prevention on the inside of the frame using Eastwood’s Internal Frame Coating Plus. Watch as shows how to apply this thick rust-stopping […]
Bagged C-10 – Episode 2: Making New Air Compressor Mounts
With the suspensions air tank freshly powder coated, work on our video producer Adam’s 1985 Chevy C-10 pickup project continues. As with other elements of this decade-old build, time has not been kind to some of the exterior hardware. The next components of the Air-Ride suspension to get his attention are […]