Sometimes it’s the little details that make a project really come together. In the case of Eastwood video producer Adam’s C-10 pickup project, that meant coordinating the finish on a couple of bed accessories. Having previously powder coated his air suspension storage tank in a bright green shade, he though […]
Video
Project Sunny – Episode 9: We Have (Body) Lift Off
Every project seems to eventually reach some insurmountable obstacle. For our Range Rover restoration project, the hurdle we couldn’t seem to jump was getting the body off the frame. Not that we didn’t know how; it was a matter of figuring out what we were going to with the body […]
The Right Way to Repair Body Damage with Rattle Can Spray Paint
Most of us probably use spray paint for small projects around the house. We might even be tempted to try repairing body damage on our vehicle with the old rattle can. But we’ve all seen the results of a botched spray bomb touch-up going down the road. And it usually […]
How to Correct Peeling Plastic Body Moldings
One of the challenges with modern cars is that a lot of trim is held on with double-sided foam tape. That’s usually not a problem as long as they never get removed, but what if you remove them for paint? Once you peel that original adhesive off, it can be […]
Mark’s Trans Am – Episode 12: Making Perfect Spot Welds
Mark’s progress on the Trans Am project continues with welding in the new tail panels. In this episode, he shares one of his secrets to getting great-looking plug welds that replicate factory spot welds using a MIG welder. With a lot of sheet metal to stitch together, he’s looking for […]
Bagged C-10 – Treating Rust Underneath the Bed
With the bed off the C-10 project for frame repair, Adam mounted it to a rotisserie to take advantage of easy access to the underside. This was the perfect opportunity for treating rust living below, including the bed supports. Because the bottom of the bed doesn’t see daylight, Adam chose […]
Mark’s Trans Am – Episode 11: Replacing a Rusted Tail Panel
In the latest installment of Mark’s Trans Am project, he addresses the rotted-out tail panel. Before installing an aftermarket replacement, he starts by cutting out the original part and treating additional rust in the surrounding areas. Watch as he fabricates new bumper mount panels from scratch. This update was a […]
Bagged C-10 – Spraying on New Bed Liner
In this installment, Adam prepares the bed of the C-10 project for bed liner application. After he’s scuffed and cleaned the bed, he rolls on rust encapsulator to trap any minor rust that may still be lurking. A coat of epoxy primer ensures there’s no issues with the bed liner […]
A Rescued Buick Grand National Revealed After 19 Years
It’s not everyday you get to rescue a legend, but one of our local shops did just that. After nineteen years sitting on a private property, Pottstown’s Hollywood Garage brought home a Buick Grand National they’d had their eyes on for years. The original paint was still there, but was […]