- No Weld Hole Repair Kit
How do you deal with a rocker panel with an undercoating on the back side.
will this work to repair holes for ham radio antenna mounts that I have on my truck roof I want to close them because i'm giving up ham radio and want to perminately close them there not big holes 1/2 holes
MY DRIVER SIDE DOOR WAS SHOT WIT AN AK47, WILL THIS WORK ON THAT SIZE HOLE.
I have (6) small (3/16" dia.) holes that I would like to fill/repair. I have access to the back of the holes, would I need to use the nylon pins or can I just place the backer sheets on the back of the holes?
How many packages do you get ?? Patching over 30 various size holes in my firewall ..
No Weld Hole Repair Kit
Item #13661 Brand: Eastwood
About No Weld Hole Repair Kit
The Eastwood No Weld Hole Repair Kit provides a quick, weld free solution to plugging 2 inch Dia. or less holes in steel, aluminum, fiberglass and plastic body panels while minimizing sanding damage and the amount of required surface preparation.
(2) 3in x 3in x 0.02in Flexible G10 fiberglass composite backer sheets, (2)3in long x 1/8in dia. Nylon retainer pins, (2) 3in x 5/8in Steel Retaining Clips, (2) Packets of Urethane Adhesive/filler
Wear protective gloves when cutting out damaged areas. Sharp edges can cause cuts. Wear protective gloves when trimming flexible fiberglass backing panels.Exposed glass fibers can cause cuts. Follow package directions carefully and wear disposable gloves when handling backer adhesive and use in a well ventilated area. The use of a NIOSH approved mask for respiratory protection is recommended. for use with exterior body panels only. Not intended for use in floor panels or structural areas.
Assembled in the USA of domestic and imported parts.
Customers also viewed:
1-step filler actually inhibits rust and self-etches, to save you time
Sands all types of flat and contoured surfaces; use wet or dryOnly $59.99