Eastwood Extreme Chassis Black Primer

Details

About Eastwood Extreme Chassis Black Primer

Eastwood’s Extreme Chassis Black® Primer is a professional-quality primer for use over bare metal, under Original or Extreme Chassis Black®, to assure maximum adhesion and chip-resistance. Extreme Chassis Black® can be scuffed but not sanded. 10% gloss.

Contents

Choose from the following:
11193Z is the 14-oz. aerosol Extreme Chassis Black® Primer that covers 8 sq. ft.
11194PZ is the 1-qt. can of Extreme Chassis Black® Primer that covers 30 sq. ft.
Both also available in packs of 12.

Instructions

Aerosol

1. Read all directions and warnings for safe and proper application.
2. Clean all surfaces thoroughly to ensure surface is free from all grease, oil, and any polysilicons. Eastwood’s PRE is recommended. Make sure that steel is free from rust. For best results use when can and surface are between 70° and 90° F (21° and 32° C), 50% or less humidity.
3. If making spot repairs, feather-edge by sanding original finish with 220-320 grit.
Do not use Extreme Chassis Black Primer over new enamel.
4. Shake can for 2 minutes after mixing ball moves freely. Use in a well ventilated area.
5. Apply by holding can 10 to 15 inches (25 to 30 cm) from surface. Spray two thin coats allowing 2 to 4 hours between coats. Opaque black color indicates full coverage has been achieved.
6. Can be top coated with Extreme or regular Chassis Black after 2 to 4 hours.
7. When finished, invert can and spray for 2 seconds to clean spray button.
8. Average coverage: 8 square feet.

Quart

1. Clean all surfaces thoroughly to ensure surface isfree from all grease, oil, and any polysilicons. Eastwood PRE (#10041Z aerosol or #10194ZP quart) is recommended. Make sure that surface is free from rust. For best results use when can and surface are between 70° and 90° F(21° and 32° C), 50% or less humidity.
2. If making spot repairs, feather-edge by sanding original finish. Do not use Extreme Chassis Black Primer over new enamel.
3. Stir for at least 1 minute. Use in a well ventilated area.
4. Contents are thinned to sprayable consistency. If desired further thin with Toulol or Xylol. For Spray-on Application: Apply two thin coats allowing 2 to 4 hours between coats. Opaque black color indicates full coverage has been achieved.
5. Extreme Chassis Black Primer can be top coated with Eastwood Original or Extreme Chassis Black after 2 to 4 hours.
6. Finished article should be allowed to dry 48-72 hours before being handled.

Accessories

Eastwood PRE Painting Prep
Paint Mixing Cups 1QT
Devilbiss Prep Wipes
Painting Tack Rags
Devilbiss Dekups 24oz
Painters Masking Tape
Painters Masking Paper
Eastwood Air Injected Cleaner
Eastwood Scuff Pads
Razor Blades

Customer Reviews

Questions & Answers