
Details
Restore a bright glow to your benchtop media blaster with our replacement fluorescent blast cabinet light. This is the inside cabinet light assembly for the Eastwood Benchtop Blast Cabinet and will only fit this model. It’s easy to plug in and hang in place so you can see when springs, pans and other parts have been thoroughly cleaned of old paint and rust.
Adding a replacement benchtop sandblaster light assembly will quickly get you back up and running if you have a burned-out bulb. See below for instructions on how to properly connect the wires for long-lasting performance. Eastwood offers free technical support by phone, email or in-store to help you Do the Job Right no matter how big or small a project may seem.
This is the cabinet light assembly for the 30721 only.
Contents
Contains one light assembly
Instructions
Blast Cabinet Light Wire Connections:
The BROWN wire spade connector MUST be attached to the switch lug adjacent to the pre-attached GRAY wire (this is the bottom switch lug).
The BLUE wire spade connector MUST be attached to the switch lug adjacent to the pre-attached BLUE wire (this is the upper switch lug).
WARNING! Attaching the wrong wires to the wrong switch lugs will burn out the circuitry in the fluorescent Lamp.
Safety
Always wear proper safety equipment when operating this type of equipment. Always fully read and understand the instruction manual before use.
Warranty
60 Day Warranty
Eastwood Offers Free Lifetime Technical Support
Click here for product SDS information
Attention California Residents - Proposition 65
