Dual-Voltage Eastwood Powder-Coating Gun gives you the most complete coverage from tight areas to large surfaces.
- Extremely durable finish
- Coat and cure in under an hour!
- Easy to apply
- Quick color changes
- Versatility with 2 settings
- Low 15,000-volt setting
- High 25,000-volt setting for multi-coat coverage over larger areas
- Increased powder adhesion
- Minimal overspray
This innovative system will allow you to achieve the benefits of powder coating small parts instead of coating them with paint. The new Dual Voltage system gives you the capability to coat small areas using the Low 15kv setting. Or coat large areas using the High voltage setting 25kv. All you need is a compressed air source (5-10 PSI from a portable tank with a regulator or a compressor) and an electric oven or toaster oven.
The Eastwood 3 Gallon, Oil-Less Pancake Compressor, with an Integral Air Regulator, efficiently supplies all compressed air requirements for operating Eastwood Powder Coating Gun systems as well as most airbrushes. The compact, efficient design also works well with some lower demand air tools, tire inflation, blow guns and many other compressed air applications.
About Eastwood Dual Voltage Powder Coating Gun and Pancake Compressor
The Dual Voltage HotCoat gun is one of the best powder coating guns on the market today. Why powder coat? Because it gives you one of the most economical,
color-durable, and longest-lasting finishes available. You'll find powder-coated surfaces are far more resistant to chipping, scratches,
fading, and wear than other finishes, and the color selection is virtually unlimited, with high and low gloss, metallic, and clear finishes available.
And thanks to the UV resistance of many of the powders, colors stay bright and vibrant longer. Texture selections range from smooth surfaces to a wrinkled
or matte finish, plus rough textures designed for hiding surface imperfections.
One 8-oz. bottle of powder (not included) covers the same area as 2-3 cans of spray paint, and clean-up is easy, since you can simply sweep-up the oversprayed powder. Contains no environmentally harmful solvents. HotCoat powder coating requires a 5-10psi compressed air source and dedicated electric oven (or toaster oven).
Air Compressor Specifications
Power Requirement: 120V 60Hz, 2.5-amp
Motor Horsepower: 1/3 hp
Tank Size: 3 gallon
Air Delivery: 1.0 SCFM @ 40 PSI, 0.6 SCFM @ 90 PSI
Cut-in Pressure: 85 PSI
Cut-out Pressure: 100 PSI
Max. Pressure: 100 PSI
Noise Decibel Level: 87 db
Power Cord: 6ft, 3-prong grounded, 18 AWG
Use a disposable dust mask when handling or applying powder. Powder, like common flour, can be explosive when suspended in the air in high concentrations. To minimize any explosion risk, sweep up—do not vacuum—powder from the floor. Cure powder in a well-ventilated area. The urethane powders we sell liberate a very minute amount of isocyanates when the powder flows out. This usually occurs about 3-5 minutes after the part is placed in the oven to bake. Wear a respirator with fresh filter cartridges when curing or inspecting flow-out progress.
Eastwood Offers Free Lifetime Technical Support
Attention California Residents - Proposition 65
WARNING - Cancer and Reproductive Harm - www.P65Warnings.ca.gov