About Mixing Wand for 1 Gallon and Quart Cans
This handy gallon and quart mixing auger is ideal for mixing paints, coatings and Elastiwrap. Simply insert it into your 3/8 inch or 1/2 inch drill and let the tool do the work. Constructed of heavy gauge steel and designed to mix the coating, not stir it. The auger head design actually pulls the coating from the bottom and elevates it to the top. The bottom of the mixer is convex so it can be placed on the bottom of the can and rotate. Easy to clean and comes with an end cap, so you store it on a peg hook or nail. Fits open top gallon and quart cans. It's 16 inches long with a 2.25 inch diameter mixing head.
16 inches long with a 2.25 inch diameter mixing head.
70467 3/8 inch cordless drill, 30003 1/2 inch air drill, 43089 Nitrile gloves, 14842 Full face respirator, 20405 paint coveralls, 51550 Concours HVLP Paint Gun,13600 3/4 inch x 100 foot air line system,20473 2 stage air dryer
Always wear eye, skin and respiratory protection when mixing paint. Mix in a well ventilated area away from open flame. Do not use at high speed, excess speed will splash coating.
made in China, 60 day warranty
Use a 3/8 inch or 1/2 inch drill, insert mixer into chuck, tighten securely. Place mixer into the bootm of the pail or can. Starting off at a slow speed, mix coating. Increase speed slowly until you have a whirlpool effect at the top of the can. Mix from 2 to 5 minutes, depending on the viscosity of the coating. Clean mixer as soon as possible to avoid coating build up.
Eastwood Offers Free Lifetime Technical Support
Attention California Residents - Proposition 65
WARNING - Cancer and Reproductive Harm - www.P65Warnings.ca.gov