close
Find Anything, Fast!

Need Support or Have a Question?

Click Here
Rust Solution Sale
  • Home
  • Eastwood Rubberized Undercoating Aerosol 18 oz
Eastwood Rubberized Undercoating Aerosol 18 oz is rated 4.4 out of 5 by 61.
Rated 5 out of 5 by from Great! This stuff is the best. After pulling the carpets on my jeep I did the floors. This has a good spread and I thought OK ill let it sit overnight. This stuff dried in 20 mins!! Took a little better than 3 cans to do entire floor of my Wrangler. I always buy 6 cans even though I wont use them all its good to have too much than too little. Jeep is nice and quiet inside and im doing the undercarriage now. Ive been buying Eastwood products for many years now. They are the go to guys for coverage and paints. Try the chessis inner coating its the best if you want chassis to last. 2 cans did my Jeep chassis. I could go on and on about Eastwood products but try them you wont be dissapointed.
Date published: 2018-08-11
Rated 5 out of 5 by from Good final coat for the undercarriage I bought 8 cans to cover a 66 Mustang, and so far I've used 5.5 to coat the entire underside of the car and the wheelhouses twice. I started with 3 coats of Eastwood's epoxy primer after the car was completely sandblasted, then I used Eastwood's brush on seam sealer to fill any place where metal touched metal. Finally, I sprayed the undercoating on top of that in two coats. I especially like the fact that it fills in all the nooks and crannies where 50 years of wear and tear have made the metal not fit so tightly anymore. My car started out as a rust bucket, but she isn't going to have water problems from now on. This stuff is highly recommended. One thing to know: the first spray out of the can is some sort of tan colored goo. Give it a quick shot onto something you don't care about, and then paint the car. Also, don't wear clothes you care about when using this stuff and do wear gloves and a mask. It sticks like glue to clothing and is a pain in the butt to get off your skin. It should go without saying that you don't want this stuff in your lungs.
Date published: 2017-05-20
Rated 5 out of 5 by from Durable High Quality Coating Coating is high quality and is durable. I've used it on new vehicles and it provides an excellent coating. It also dries fast.
Date published: 2016-08-30
  • y_2019, m_2, d_17, h_23
  • bvseo_bulk, prod_bvrr, vn_bulk_2.0.11
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_61
  • loc_en_US, sid_16007Z, prod, sort_[SortEntry(order=RATING, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_eastwood

I want to reduce road noise.

Asked by: Jack
This will protect the vehicle from corrosion as well as reduce road noise.
Answered by: Kelly H
Date published: 2019-02-12

I picked this up because the back of the an states "may be painted over" and wanted to spray a single stage urethane over this to complete my restoration and protect the underside but reading some of the answers and your stating it cant ?!? Is that true?

Asked by: scon
We apologize for the confusion as painted over was referring to top coating with fresh undercoating from time to time. This way the surface continues to stay soft, if you were to paint over this product with a single stage paint the surface would harden and possibly cause the paint to fail prematurely.
Answered by: Scott C
Date published: 2018-08-21

Is there a discount for 8 cans of the 18oz. Aerosol 

Asked by: Riverdog
For pricing questions please email our Customer Service team at Orderhelp@Eastwood.com.
Answered by: Scott C
Date published: 2018-08-06

What type of sheen does this have when dry? The old undercoating I used had a slight sheen to it like the factory used in the 50's and 60's. The stuff at the local parts stores is now flat.

Asked by: Mike
This will leave a Matte finish
Answered by: Bob G
Date published: 2018-07-19

I have a 79 Trans Am that I am restoring. It currently has factor rustproofing underneath. Can I just clean up this surface and spray the Eastwood product over the factory rustproofing?

Asked by: Mereness
You certainly should be able to rough the existing undercoating up with a red scuff pad and some cleaner to prep for new rubberized undercoating.
Answered by: Scott C
Date published: 2018-08-14

I cleaned my old oil soaked car frame with POR's metal prep, but the POR's final coat is peeling. What do you recommend I use to re-prep and then apply this undercoating?

Asked by: Mark ii
We would recommend removing all of the failing paint, even in areas it didn't start to peel as it has the potential to fail. From here you would want to wipe all the areas to be painted with our Pre Painting Prep to ensure the surface is thoroughly clean and ready for paint.
Answered by: Scott C
Date published: 2018-03-15

What is the minimum air temperature that this product can be applied in?

Asked by: prettyslick65
We do not recommend applying any of our paints below 60F to ensure they properly flash in between each coat.
Answered by: Scott C
Date published: 2018-03-13

How much coverage per aerosol can?

Asked by: Sparky232
Each aerosol will cover about 7 SQ FT.
Answered by: Scott C
Date published: 2017-11-13
  • y_2019, m_2, d_17, h_23CST
  • bvseo_bulk, prod_bvqa, vn_bulk_2.0.11
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_34
  • loc_en_US, sid_16007Z, prod, sort_[SortEntry(order=LAST_APPROVED_ANSWER_SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_eastwood

Eastwood Rubberized Undercoating Aerosol 18 oz

Eastwood Rubberized Undercoating Aerosol 18 oz

Item #16007Z

Protects your car's underside
against rust; reduces road noise
Quantity:
Quantity: close

In stock

Only $12.99

Sale $10.97

 

< Back

Details

Durable Rubberized Undercoating protects your car's underside against rust

  • Protects against rust and corrosion
  • Reduces road noise
  • Perfect for wheel wells
  • Dries fast, stays flexible

Eastwood's Rubberized Undercoating stands up to the most extreme conditions to protect your vehicle's underside from rust, road salt and corrosion.


More info...
< Back

About Eastwood Rubberized Undercoating Aerosol 18 oz

Rubberized Undercoating develops a very tough, flexible film that stays put. Excellent adhesion to metal or painted surfaces. Buy 3 or more and SAVE!


Contents

Contains net weight 18.3 ounces, Covers up to 7 square feet.


Accessories

Buy 3 or more and SAVE!


FAQ’s

use a heat gun and dull putty knife to remove undercoat.


Safety

Work in a well ventilated area when applying this product. The use of a respirator like our SAS Bandit Respirator (11455 or 11456) is recommended when applying this coating.


Warranty

QUANTITY DISCOUNTS AVAILABLE FOR THIS ITEM


Application

Use Rubberized Undercoating 18.3oz Aer for touch up in wheel well areas. One can covers about 7 sq ft and withstands up to 200 degrees F. This resilient black coating protects the surface against chips, and deadens sound. The dried coating can also be painted. To completely undercoat the underside of your car, use Rubberized Undercoating (16008 ZP) Qt. (Average 2 needed); and apply Heavy Duty Anti Rust (16017 ZP) in rocker panels, doors, and other boxed sections. Use a heat gun and dull putty knife to remove undercoat. Use in a well ventilated area or wear a respirator.


Click here for product SDS information


Attention California Residents - Proposition 65


Proposition 65 Warning WARNING - Cancer and Reproductive Harm - www.P65Warnings.ca.gov


< Back

Customer Reviews

< Back

Questions & Answers

Customers also viewed: